Jointing Systems

Pipes & Fittings made from Polyolefin’s are joined by thermal or mechanical systems. The most important thermal methods are heated tool butt-welding and electrofusion welding, while mechanical methods involve push-in, clamp or compression joints. The typical application for these different systems are listed below.

This is heading element

Butt-fusion jointing is a thermofusion process which involves the simultaneous heating of the ends of two components which are to be joined until a melt state is attained on each contact surface.

Read More>>

SOCKET & SADDLE FUSION

In the electrofusion method, special fittings are used that contain an internal electrical heating coil that is connected, via terminals, to a source of direct current. The heat generated causes the inside

Read More>>

ELECTROFUSION

In the electrofusion method, special fittings are used that contain an internal electrical heating coil that is connected, via terminals, to a source of direct current. The heat generated causes the inside

Read More>>

MECHANICAL FITTINGS (TAK,VICTAULIC & STUB-FLANGE)

Victaulic Jointing System uses standard steel clamps, requires only two fastening bolts and is easily and quickly installed. It is robust, with exceptional mechanical strength,

Read More>>